-
3 Benefits of Pre-Construction Soil Testing 14 July 2023
-
The Benefits of Working with a Land Surveyor 24 January 2023
Efficiency Tips Related to Concrete Pump Use When Pouring Concrete Patio
Lawrence Kim
A concrete pump is a piece of equipment that you can use when you are looking to create a concrete patio on your property. But not everyone owns their own concrete pump, which is why hiring one is a good idea. Not only do you need to know how to effectively operate a concrete pump, but it is also important to understand how to set up and clean up to maintain efficiency when pouring a concrete patio. There are a few setup and clean up tips that will enable you to save time and complete the task of pouring concrete in the shortest amount of time possible.
Checks
Before you begin using a concrete pump, it is essential that you go through a few checks to make sure that this equipment will function properly. This always begins with checking the fluid levels of the pump. This means that you need to make sure that the oil and hydraulic fluid levels are sufficient. It is also recommended that you set up your concrete pump by checking the water box and making sure that the machine is properly greased.
Hose Set Up
The hoses on a concrete pump are extremely important and can become obstructed. This means that you always need to check inside the rock valve and S tube for possible obstructions before you begin. You stretch the hoses on the concrete pump using clamps, which is recommended.
Slurry
It is also suggested that you coat the hoses with slurry before you begin pumping concrete through. You can place the slurry into the hopper right before you are ready to begin pouring concrete. This allows you to coat the walls of the hose with the slurry instead of the concrete. This lessens the chance that the rubber hose will suck all the grout off of the concrete as it is pushed through the hose. Concrete can sometimes clog the hose as it is being pushed through, but this is less likely to occur if you use slurry first to coat the hose.
Water
It is also suggested that once you have pumped the hoppers as low as it will go that you fill the hopper with water. This will enable you to begin pumping again to push the concrete that is left within the hoses through with water. Those that are holding the hoses should be instructed to stop pumping once they notice the water coming through. After the hoses are free of any concrete, they can be disconnected completely with ease.
Share